Introduction

Fluorine lined butterfly valve is in the conventional butterfly valve and valve plate lined with teflon, so that the media and valve body isolation, antiseptic effect. The valve has more and more close closure function, sealing performance is reliable. Applicable to any concentration of acid, alkali, salt and oxidative extrusion, reducing agent, organic solvents and other media.

Pneumatic Actuator

Technical Parameters

Outline Size Drawing (Valve)

Unit:mm

Actuator Models: AT52, AT63, AT75, AT83, AT92, AT115, AT25, AT140

Maintenance

1. Tightening the seal between the valve and the actuator:

Remove the four bolts underneath the actuator. Separate the actuator from the valve.

Tighten the nut on the top of the valve body.

Place the actuator back on the valve and screw everything back into place.

2. Tightening the seals between the valve and the inlet/outlet ports.

Remove the torque bolts and check for any debris or damage to the gaskets.

Use a torque wrench or other consistent method of tightening the torque bolts to reconnect the inlet and outlet ports.

Pneumatic Actuator Specifications

Operating Media: Dry/lubricated air or non-corrosive gases (max particle size <30µm).

Air Pressure: Min 2.5 Bar, Max 8 Bar.

Temperature Range:

Standard: -20°C to +80°C

Low: -35°C to +80°C

High: -15°C to +150°C

Common Faults & Troubleshooting